In my SW2017, only the 2D sketch buttons are available.
The 3D set shown isn't exposed for customization.
Perhaps it's an issue for your VAR or to create an ER/SPR.
Sorry, not much help,
In my case...(SW2017)..and i believe default.
The "along vector" buttons only are avail, AFTER a 3D sketch line is draw. If you access it DURING line creation, they are not avail.
True, you must be in the middle of a #D line for these to show, but I took it from the OP that they weren't available during customize.
So, Tom Hickerson, which is it?
- Was the other occurrence tried when a 3D line wasn't active?
- Or, is this post about not being able to add the Move Along buttons?
As others have stated, you get those icons allowing you to apply the relations when you select a line in a 3d sketch. Are you sure that you're using the same workflow on the other machine when they don't show up?
After more testing....
On my machine if while I am in the middle of drawing the line. First point set, and second point not set I can right click and get the popup above with the along X, Y, and Z.
On the other machine. Same version of solidworks 2017 SP3 when I right click in the middle of line creation this is the popup I get.
However on my machine when I click along x,y, or z. It doesn't actually set this relation in the table. I thought it was, but its not. So in the end all of this doesn't matter, but the pop ups are very different when right clicking.