0 Replies Latest reply on Feb 6, 2018 10:28 AM by Tim Behrman

    How to give knitted surfaces thickness [for use in ANSYS Fluent] 

    Tim Behrman

      Hi folks
      I'm making aerodynamic surfaces, see front motorcyle fairing below:

       

      I cannot thicken the knitted surfaces to a thickness below 6mm. When I thicken them to 6mm (or above) and export part into ANSYS (as an IGES file), it is only recognised as a series of surface bodies, and therefore cannot be used to run and CFD. Thickening the surfaces individually then knitting them does not help.


      I would appreciate any help offered.

      Cheers, Tim.