3 Replies Latest reply on Feb 6, 2018 5:10 PM by Hitendra Chaudhari

    3D Sketch Pipe - Fixture

    Art Garibay

      I have been tasked to create a FIT CHECK Fixture for a 3D Sketched Pipe (similar to the attached pic). What I did was create a circular sweep along the 3D Sketch path, but they are in need of a U-Channel groove. When I try this, the U-Channel rotates when following the path.  I need the path to be constant so I can drop in the pipe below flush for check.

       

      Any help or ideas would be appreciated.

       

      -Art