0 Replies Latest reply on Feb 2, 2018 5:58 AM by Thomas Sroga

    Particle Study Problem

    Thomas Sroga

      Hello. I made a flow simulation for a tank I am studying for one of my university courses. The flow trajectory looked fine but I could not get the particle study to work properly. I selected the inlet lid as my injection point with the desired mass flow rate, and the particles flowed vertically through the cross-section of the pipe instead of through the tank. The fluid used in the simulation was water at 323.15K with a .15kg/s mass flow rate. I tried using other injections but I got the same results. Does anyone have any suggestions? 

      Particle Study.PNGParticle Study2.PNG