3 Replies Latest reply on Jan 29, 2018 8:25 PM by Dave Bear

    Bolt Hole Mesh Problem

    Mohamed Imthiyas

      Hi I tried to mesh an imported part from Solidedge . The following where the procedures I followed.

      1) Converted Solidedge to Parasolid

      2) Ran feature recognition in Solidworks

      3) Gave material A5052

      4) Didnt give any connections

      5) Fixed the bottom face

      6) Used Prescribed Displacement for external Loads and gave 60mm

      7) Ran mesh

      8) Error- Unable to mesh Part 1...

      What should I do ?