Hi... Simple question.
Can you move a schematic symbol around and have the wires remain automatically attached?
I know it works with line diagram symbols. But tired of reconnecting wires and re-associating cores every time I adjust placement on a connector.
Thanks!
Unfortunately no. Would be a good SPR to post. I'd vote for it.
Yeah, the closest thing is the "stretch" command under the Schematic tab, which works if you are moving symbols with wires in line.
Hey that's the ticket... Works very well. Thanks Evan!
Hey, good to hear! It's not perfect, but better than nothing, right?
No, Actually i was trying for the same for one of my project before a couple of months but it is not possible
Thanks Evan, i tried the way u suggested "to use stretch command". It's helpful
Yeah, the closest thing is the "stretch" command under the Schematic tab, which works if you are moving symbols with wires in line.