6 Replies Latest reply on Jan 24, 2018 4:26 PM by Ben Ben

    Flow Rate Simulation Advice Please

    Ben Ben

      I am hoping to set up a flow rate simulation to test the flow rate of some perforated strainer baskets.

      as a complete newb to the simulation side of solidworks, I thought I'd ask for some advice.


      Basically, we manufacture a large range of industrial strainers with a variety of perforated basket sizes.

      I wish to be able to measure the flow rate in compared to the flow rate out of the strainer for all basket configurations.

      Is this possible?


      Right Angle Strainers_Page_1.jpg