0 Replies Latest reply on Jan 23, 2018 5:24 AM by Jose Antonio

    Help with complex surface knit and trim

    Jose Antonio

      Hello everyone, following my previous discussion, I am still trying to create a stamping die. However the imported surface has had many errors due to being imported from Catia V5, now partially solved.

      My final goal is to create the lower and upper dies for hand stamping.

       

      Problems I am facing:

      1) I am not able to knit the grey surface with the yellow into one gapless surface

      2) Trim the green bow using the grey surface (solidworks say they do not intersect) and lags hard

       

      I am stuck, so if anyone has any ideas on how I should proceed next I would be really grateful.

      Thank you