AnsweredAssumed Answered

Error Message: Soft spring is too stiff. Modulus of elasticity is too large or too small.

Question asked by Nick Vanderkamp on Jan 19, 2018
Latest reply on Jan 22, 2018 by Nick Vanderkamp

I am trying to simulate the stresses of a shaft inside two bearings. I am using no penetration contacts.

I was able to run the simulation before, but now when I try to run the simulation  I get the below error message.

error message.PNG

I have tried turning the soft spring stabilization on and off.  That doesn't help.

 

any ideas??

Outcomes