I'm on SW2015 SP5 and I'm looking for create a linear component pattern in three directions but I don't think it's possible in SW2015. Is this function implemented in future versions?
Whenever I had to do this I did on pattern in the x & y direction then do another pattern of that pattern in the z direction.
Yes, I do the same at the moment, but it's a pain when I need to select/show/hide parts inside the configurations as they are spread into separate groups.
And having another direction it's useful not just for third dimension, but also because I sometimes do this:
I could show the 4 box section on the other side of the plate too, if I had another direction.
Use sketch driven pattern.
Retrieving data ...