6 Replies Latest reply on Jan 17, 2018 11:32 AM by Timothy Masocol

    "Convert Entities" on a curved line

    Timothy Masocol

      I created a thin extruded feature that i then drafted 3 degrees outward a certain distance (not important). Then, the tail-end of that feature, I created a sketch and used the outer curve by using "Convert Entities" to then use "Extruded Surface" and extrude a surface using that outer curve. It looked fine from far away, however, the area where the two "intersect" from when zoomed in doesn't look like the two features are using quite the same curve. There seem to be some peaks and valleys between the two, despite generally following the same outer line. Any help on this?