4 Replies Latest reply on Jan 15, 2018 12:42 PM by Samir Panchal

Default open mode

Jake Bakerin Jan 15, 2018 11:52 AM

How do you setup to specify the default open mode?

Some of my SW assemblies are open in Lightweight while others are in resolved?

I want all default open in resolved, other options are selected only at open

Re: Default open mode

Alex Burnett Jan 15, 2018 11:55 AM (in response to Jake Bakerin)

It's in the system options under performance. Check/uncheck the "automatically load components in lightweight" box and "Always resolve subassemblies". Additional performance functions are in there for Large Assembly mode as well in the Assemblies menu under Performance.
Like Show 4 Likes(4)

Actions
- Re: Default open mode
  
  Jake Bakerin Jan 15, 2018 12:00 PM (in response to Alex Burnett)
  
  should I mention here some are default in Large Design Review
  I only want "resolved" for all assemby
  
  Like Show 2 Likes(2)
  
  Actions
  - Re: Default open mode
    
    Alex Burnett Jan 15, 2018 12:39 PM (in response to Jake Bakerin)
    
    Jake Bakerin wrote:
    
    should I mention here some are default in Large Design Review
    I only want "resolved" for all assemby
    I don't believe those options apply to Large Assembly Review mode.
    
    Like Show 2 Likes(2)
    
    Actions
  - Re: Default open mode
    
    Samir Panchal Jan 15, 2018 12:42 PM (in response to Jake Bakerin)
    
    Change settings
    
    Like Show 2 Likes(2)
    
    Actions