Hello everyone (new here),

I used to work with PTC Creo for a while, and I must say: I like its zooming behaviour.

Since I am working with Solidworks again, I tried to adjust the zooming behaviour, but without succes.

Solidworks' default zooming behaviour is: zoom IN to pointer, zoom OUT to center of the screen

The one thing I'm looking for is zooming OUT to the pointer, like in Creo.

I like to 'pan' by zooming in and out around the model, and with the current settings that takes much longer..

Can somebody tell me if there is a setting or a workaround to get this done?

Thanks in advance,

Klaas-Jan