-
Re: How to show configuration name if different from ‘Default’
You can link the note $PRPSHEET:"SW-Configuration Name(Configuration Name)" to display the config name.
-
Re: How to show configuration name if different from ‘Default’
I know, but I only want this to be shown if it’s different from ‘Default’
-
Re: How to show configuration name if different from ‘Default’
Set up an equation in the model to create a property to display the config name and blank if it is default. Create a property and link to that equation. Then in the drawing link to that property. And then property value would show as blank or config name.
-
Re: How to show configuration name if different from ‘Default’
Can you help me with the syntax please? :-)
-
Re: How to show configuration name if different from ‘Default’
Sorry my bad, I thought one can reference to configuration name in equations. But do not worry, you can do it via design table (check attached file)
-
-
-
-
