AnsweredAssumed Answered

Advice on this sheetmetal cut please

Question asked by Rob Edwards on Jan 12, 2018
Latest reply on Jan 18, 2018 by Jeremy Descroizilles

I would like to cut the curved bottom bit to a constant width the same as the straight section

To give an approximation and a better visual, here it is just eyeballed with an elliptical cut


If I unfold it, it's easy but the cannot fold it back, if I create a surface I get ZTG..


I normally enjoy this kind of challenge, but now I've got brain freeze.


Hoping you can help


2016 attached