AnsweredAssumed Answered

Issue Promoting Assemblies in BOM

Question asked by Mitchell Frechette on Jan 10, 2018

Hello all,

 

I have a slightly complicated situation where I would like to make a BOM of several configurations, while promoting some of the sub assemblies in the BOM. I am using a top-level only BOM to accomplish this, and have done so successfully with other drawings. This one, however, is being more difficult and I can not seem to figure out why. For starters, the icon that appears on the left side for each part/assembly when you extend the BOM shows an icon for a part rather than an assembly. If I try to right click then component options, I still have the option to promote the sub components. However, only one of the configurations will actually promote, the other configurations will not dissolve when "promote" is selected.

 

Thanks for any help!

Outcomes