Just today I noticed an issue that when I tried to add/subtract from a dimension in a part file it automatically truncates it to less decimal places.
Example: If I have a dimension at .2384934 or anything and then I go to edit it and enter -.003 at the end instead of displaying .2354934 it cuts off everything and just changes the dimension to .235. I've never seen it act like this prior to today.
It is not simply a display issue because if I look at the dimensions in the toolbar on the left it shows it is actually 0.235 and everything after it is lost. In all cases it is cutting it down to the .001 place.