AnsweredAssumed Answered

Imitate cutting tool corner radius with fillet

Question asked by Mikko Laine on Dec 28, 2017
Latest reply on Dec 29, 2017 by Mikko Laine

I'm having slight trouble modelling part of a plastic extrusion tooling.

 

What I'm trying to do is to fillet this corner with R3 fillet so that the radius should be tangent to vertical sides... If the fillet is smaller than the edge on the left (0.8 mm) the fillet will come out as supposed but with anything over that it fails.
fillet_1.jpg

There must be some kind of work around to achieve this.

Attachments

Outcomes