AnsweredAssumed Answered

Edge Flange Interfering

Question asked by Raymond Diangelo on Dec 27, 2017
Latest reply on Dec 27, 2017 by Raymond Diangelo

I'm trying to add an edge flange but it interferes with the other flanges. I tried doing a cut on the corners but there's no option to just cut the one feature since all bodies are merged. I tried drawing a cross section sketch and extruding both direction to offset from the other surfaces but with this I can't get a proper flat pattern. And I don't know of any way to make the edge flange automatically trim corners. Also, I can't just do the edge flanges together because of the 4 degree slope on the top end (or at least I can't figure out how to). Any ideas? Thanks.

Outcomes