may someone help me with this drawing, I have tried many times, and I couldn't do it.
See #32 at FAQ - Part 2.
I'm having problems with the arcs, the draw gives me radius, but i dont know where is the center point, or the points to create the arcs
Do you mean the R100 Arcs?
This looks to be a single arc that is tangent to both corner arcs. So, since it is tangent to 2 arcs and the radius is defined, this arc is fully defined.
can you teach me how to do it, please?
First of all...read this:
Some very important steps if you are a NEW FORUM USER....
Also, I was wrong. That 100mm radius doesn't connect those corner arcs. It turns out it is impossible. If I had been paying more attention, I would have seen that Sorry about that.
Retrieving data ...