AnsweredAssumed Answered

I want my flat pattern to look like the unfolded part

Question asked by Wes Craig on Jan 29, 2009
Latest reply on Jan 29, 2009 by Wes Craig
Hello,

I apologize if this has been covered here before. When I flatten a sheet metal part that I have closed the corners on, I don't get the relief that I need. When I unfold the same, I get the correct flat pattern.

What am I doing wrong?

I am using Professional 2009 SP2.0

Thank you for any advise you may have.
Wes

Attachments

Outcomes