Is there a way of setting the HW depth to be the dimension from face to drill point, rather than drill shoulder?
I.e. when I specify 80 here:
The value that is 86.6 on this view would be 80 instead, and the 80 would be (driven) as 73.4?
This has been a long standing request and has been issued a SPR, but is still listed as Open.Add your vote at the KB and ER sections to escalate the issue.
Not that I'm aware of. However you can edit the sketch, make the current 80 dimension driven and add a dimension to the drill point making it 80.
Sounds like a good enhancement request.
Retrieving data ...