2 Replies Latest reply on Dec 7, 2017 10:20 AM by Rick Becker

    diametric dimension for detailed drawing

    Tommy Kowalczyk

      I am looking for a way to use a diametric dimensioning method for my partial section view of my drawing (*.slddrw).  I have the top view showing the radial features but for the front view, I have a partial section view.  In the front view, I want to be able to dimension the radial dimensions off of the radial edges and tie them to the centerline.  However, whenever I do this, it only gives me the linear dimension, without even the diameter mark (Ø).  The opposite side of these cylindrical edges are not visible (since they are internal to the front view).  For this reason, I want to use the diametric feature to dimension it.

       

      What I want the view to look like:

      Capture.JPG

       

       

      What I have to do to dimension the diameter:

      Capture2.JPG

       

       

      Any thoughts?