I'd like to use a variable fillet but have different profiles assigned to different sections. So V1 R= 5mm but Circular and V3 R=10 but Curvature Continuous. Is this possible? If not, what is the way around this?
This isn't possible, but you could do each section and untick "tangent propagation". Then eachfillet should only be created on that section and you can set the curvature type
I used to say that no CAD system should define what MY geometry looks like! As long as it is geometrically possible.
Not knowing your exact geometry I would still say it is possible with a - difficult - workaround. Perhaps you need to Split your part in three sections (one R5, one R10 and one for the transition). The transition can then be made using splines and surface modelling.
Not necessarily an easy task but in most cases possible.
Retrieving data ...