2 Replies Latest reply on Dec 3, 2017 9:57 AM by Maha Nadarasa

help on redimensioning this part?

Andi W. Dec 3, 2017 5:32 AM

I've been trying to re-create a Kant Twist Clamp's dimensions for an assignment, but have spent hours attempting to re-dimension the parts attached to the dimensions shown in the images below. These are the only two parts I have struggled with, and I would really appreciate any help. Thank you for your time.

Hinge B.SLDPRT.zip 69.9 KB
Shaft (1).SLDPRT.zip 125.4 KB

Re: help on redimensioning this part?

J. Mather Dec 3, 2017 7:57 AM (in response to Andi W.)

Simply enter the units with the number (.50in) and SolidWorks will convert to mm for you.
Like Show 1 Likes(1)

Actions
- Re: help on redimensioning this part?
  
  Maha Nadarasa Dec 3, 2017 9:57 AM (in response to J. Mather)
  
  Thanks for the information.
  
  These type of dimension can indicate two factors:
  
  Converted dimension.
  Derived from already existing sketch dimension.
  
  Is there any way to distinguish easily? I mean without going to property manger.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post