I need help creating a 5 deg draft on this aluminum casting link.
Blue circles represent the location of the draft,... see actual picture of the draft on the slots..
I've also attached the part file for you guys to try, Thanks!
I'd start with a solid 'bar'. Sketch seven squares on one face of it. Extrude-Cut with Draft applied. Then Mirror the extrude-Cut, or reproduce it manually on opposite side. Finally, make a non-drafted cut on your hinge forks at the one end if those don't include same draft.
Repeat for all of the pockets.
Fillet as required.
If I'm seeing the piicture correctly, I think you'll need to remove the corner fillets in each opening, do the above and then fillet afterwards,
Drafting the fillets as above turns them into cones which isn't realistic for a core.
Filleting afterward, I believe will generate a cylindrical radius.
You can add 5 deg when in the cut feature - see below image
Edit: Opp.. sorry ... you only want to add draft on one side - then you need to use draft feature. But best to remove fillet on your sketch and apply it after draft
See att. file
Along the lines of Mr. Chu's post
You can then use the draft option of Extrude-Cut to satisfy the OP(As I stated above, for a more realistic corner draft, the cut sketch must be modified to remove all corner radii, then fillet after the draft.)
Retrieving data ...