Mark Thompson

Routing around a hinge

Discussion created by Mark Thompson on Jan 27, 2009
Latest reply on Feb 6, 2009 by Andy Hughes
I have create a harness around a hinge. The route includes two clips on either side of the hinge, and multiple-point spline between the clips.

The harness model was originally created with the door in an opened position. Closing the door to zero-degrees causes the original sketch to fail. However, closing the door 5-degrees at a time works, but only to 50 degrees of being closed. Closing beyond a certain angle causes the sketch to fail.

Any best practices?

Outcomes