-
Re: Hi! How do you add ++ sizes to dimension tolerances?
Choose bilateral and type in the +-sign for the lower value:
-
Re: Hi! How do you add ++ sizes to dimension tolerances?
Thanks that’s great! Simple when you know how! Cheers!
-
-
-
Re: Hi! How do you add ++ sizes to dimension tolerances?
You really need to spend some time with the dimension property manager.
that or take a look here.
along with the place that Per Engberg showed you. You should start to be able to get what your looking for.
-
Re: Hi! How do you add ++ sizes to dimension tolerances?
Dave,
What version of SW are you referring to? I do not remember a version where this could not be done
-
Re: Hi! How do you add ++ sizes to dimension tolerances?
Solid Air wrote:
Dave,
What version of SW are you referring to? I do not remember a version where this could not be done
I think Dave may be referring to a drafting standard/policy rather than software limitation. There are still some folks who don't understand the concept of +/+ or -/- tolerances.
-
Re: Hi! How do you add ++ sizes to dimension tolerances?
YEP +/+ makes little sense ...if you can be bigger make it bigger. Then again I was always show to use the bilateral tolerance to min max dims...Think I tried the +/+ things once way back in 2001 or 2 that year we had 20+/+ service packs.
-
-
-
Re: Hi! How do you add ++ sizes to dimension tolerances?
Des,
Small note if you hang around here a while... No need to reply to every person individually. Every person who has posted in this thread will see all your replies, so just one is OK.
-
-
-
-
-
-
-
