Hi again,

This question is very similar to my first one, now just reversed.

I'm trying to get the two horizontal flanges to meet at a 45 degree angle, then I will have another edge flange drop down perpendicular to the two horizontal flanges.

Any thoughts on the best way to go about this?

I tried to flatten and sketch the triangular shaped extensions; that didn't please SolidWorks however.

Attaching picture.

-- Matt

This question is very similar to my first one, now just reversed.

I'm trying to get the two horizontal flanges to meet at a 45 degree angle, then I will have another edge flange drop down perpendicular to the two horizontal flanges.

Any thoughts on the best way to go about this?

I tried to flatten and sketch the triangular shaped extensions; that didn't please SolidWorks however.

Attaching picture.

-- Matt

Thank you once again for all the help!

-- Matt