Can somebody please confirm that you cant balloon perspective views properly? The arrows don't touch the part and then when I drag them to tough they all say the same number.
If it is possible can you let me know how to do it.
That's my understanding. The best SW can do is balloon isometric views.
That the conclusion I came to. Shame it cant be done. Hopefully it on the list of things to fix.
Steve Crompton wrote: Hi That the conclusion I came to. Shame it cant be done. Hopefully it on the list of things to fix. Thanks Steve
Steve Crompton wrote:
Hi Bjorn and Steve - this issue is in the system as:
SPR 237429 - Balloons are not attached to geometry properly in drawing view with Perspective on
To add an additional "hit" against it, you can search for it in the SOLIDWORKS Customer Portal Knowledge Base, then associate your account to that SPR using the button shown below.
I just tried doing just that but I get the attached error message.
Steve Crompton wrote: HiI just tried doing just that but I get the attached error message. Thanks Steve
When did the error occur? When logging in to the Customer Portal? When clicking on the Knowledge Base? When searching in the KB? Or something else?
When I went to press reply having ticked the box.
OK I'm not entirely sure why that's happening, I just tested it and it worked OK so I'm guessing it may be related to your account or your browser.
You could try with another browser. If that doesn't work you could ask your reseller to associate your account with that SPR, and also perhaps they could contact our Customer Center team to figure out why you can't tag your account to that SPR yourself.
Just tried it in chrome as opposed to IE and it worked.
Retrieving data ...