Do you see any advantages of Dynamic Mirroring over Usual Mirroring? In my view only difference in Dynamic Mirroring is mirroring can take place while sketching.
dynamic mirror is only available in sketch mode anyway - at least in SW2016
I used the static mirror for several years before I found out about the dynamic mirror. I like the static mirror better because if I delete a line in dynamic, then I have to delete the mirrored line. By using the static mirror I can make sure I have my sketch correct before I mirror all of the lines.
it is just a faster way to design a symmetric part. Sometimes the standard mirror tool doesn't apply appropriate sketch constraints. Also can help to clean up your feature tree depending on your modeling practices. Both have their own benefits and issues.
Retrieving data ...