I want to make this 3d model in solidworks
and this is where I reached
the only remaining thing is the arches on both sides, I tried to use the fillet but it doesn't work
and the radius should be 35 mm
Take look at this model... But i think you should first go through some basic modeling lessons or tutorials..
but which type of arches did you use?
if you cant use the fillet command try drawing the profile you are after and then either doing a cut extrude or a extruded boss
Hope that helps
Draw a sketch on a face as shown or the Right Plane. This is assuming the height of your part is correct as the arc is tangent to the top edge. If it's not you will have to dimension the centre of the arc.
Then just Extrude Cut, making sure the arrow is pointing to the correct side for material to remove.
Also note that Cut-Extrude1 & Cut-Extrude3 could of been done in one sketch & one feature. Cut-Extrude4 could also of been done using the Chamfer tool.
thank you so much
Just a suggestion, have you watch any of the tutorials in solidworks or you tube?
Retrieving data ...