AnsweredAssumed Answered

Pipe Coping, Automatic Blunt End

Question asked by Todd Kukoleck on Oct 14, 2017
Latest reply on Oct 14, 2017 by Solid Air

I am curious if this is even possible & I didn't see a discussion asking this.  I there a way where you can automatically create the natural blunt end (Detail A & B) for coping pipe instead of the unrealistic sharp point (Detail C & D) for a pipe cope?  Because when creating a cut list it takes into account from sharp point to sharp point. I can automatically create the weld gap but that's all I can find. If not, this seriously needs to be added to weldments in the next version or SP.

Attachments

Outcomes