Hi all. I'm having a bit of an issue and your help is greatly
appreciated.
I opened an idf. of a PC board file in circuitworks then modeled it into solidworks, it came in as an assembly, then I made some mechanical changes to the board. All I did was add a hatch sketch and 4 little holes. The problem I'm having now is getting it back into circuitworks and export it as an idf. file again, to be opened up in Mentor Graphics.
Thanks
Dave
I opened an idf. of a PC board file in circuitworks then modeled it into solidworks, it came in as an assembly, then I made some mechanical changes to the board. All I did was add a hatch sketch and 4 little holes. The problem I'm having now is getting it back into circuitworks and export it as an idf. file again, to be opened up in Mentor Graphics.
Thanks
Dave