As seen in my screen cap, when I add center marks to the radii in a detail view of a cavity only the portion of the center mark within the outline is visible. I've never ran into this problem before and I cannot figure out how to fix it. Does anybody know a way to have the entire centermark show? I've already tried the "No outline" option but it didn't change anything.
Thanks,
Cody
Can you upload your drawing and part/assembly.
Just played around with this, seems to be a bug.
I have found a few times where the center mark from a center mark set gets corrupted (or something), and even if I delete that single center mark from the set and replace it, it still comes in like your picture.
What I had to do to fix it was replace the entire center mark set. That was the only way I could get it to work right.
If you RMB on of them and select "Select Center Mark Set", then you can delete the entire thing as one piece.
