I made my plan to make a cube then extrude it then do the remaining cuts
but I think the top surface should be chamfered
and I dunno how to use it in my cube to make it look like the one above?
I made my plan to make a cube then extrude it then do the remaining cuts
but I think the top surface should be chamfered
and I dunno how to use it in my cube to make it look like the one above?
I uploaded the sloidworks on a macbook so it's hard to take a screenshot and post it here
so far I reached a full extruded cub with 82 width 67 height and 32 depth
...if you want to post a image.. you have a few options within Solidworks
1 - Save As (...jpg, png, pdf)
2 - Print (pdf)
3 - View / Screen Capture / Image-Capture
Are you talking about the three 30 degree cuts?
If so, then I would either add those at the end as an angled cut, or add them in initial extrude shape.
how I proceed ?
I posted my work in the title part
it doesn't show up here somehow
Your Sketch1 does not look like my Sketch1 in image above.
I think I should have sketched a rectangle first
I'll delete this sketch
Why did you start another thread ?????
You are only showing us a picture....