I am making an assembly a snapshot of which I have attached.
I have only set concentric mate and face coinciding mate here.
I want the assembly to rotate along threads when it is moved and stop moving where the threads lock in to each other(the threads end).
How can this be done?
Cosmetic mates or threads?
Oops, my bad...Edited the post
The screw translates one component in a linear direction while the other rotates, and vice versa. This should work well and be less complex than using tangential mates within the threads and then limiting it's motion at the end of the threads!
Hi,
Mates Feature; Mechanical Mates; Screw.
I would also use cosmetic threads in this part to save on rebuild time unless there is a physical reason why you need them.
Olly