AnsweredAssumed Answered

Changing components position

Question asked by Edmond Husseini on Jan 20, 2009
Latest reply on Jan 21, 2009 by Edmond Husseini

I have an assembly of an engine's camshaft lobe, follower and valve that I'm running simulations on.

The simulation runs fine but then I go back to the assembly and change the angular position of the camshaft. I would then like to re-run the simulation with the camshaft lobe starting in the new position, but the components in the simulation go back to their original postions when I try to recalculate the simulation.

I have tried rebuilding, Control-Q, selecting/deselecting 'Orientation and Camera Views'. It seems the only option I have is to create a new motion study with the camshaft lobe in the new position, is this true?

Any help is much appreciated!