the back view of the part is missing so I didn't know the execute the features, if someone can please check it to determine the errors.
Where did you go this picture from? Was there any additional notes or instructions?
Deepak,, I got my information from a CSWA EXAM GUIDE. Although the guide shows the steps to complete it (and location or the origin), the picture that Imad shows is really all they expect you to go by.
I only got this view that's why I had problems with the rear view, thanks
Imad... You are off on a couple of dims. Double check those. In the screenshot below is my model (in green) and your model (rust color transparent). I know that it's difficult to determine how the rear is supposed to look by the drawing but you can see by my green model how it should be.
Edit:... This is what your mass properties should look like. Note my origin is in the corner.
thanks a lot it worked perfectly, I had errors in rear view because I didn't had all the views,
..quickly looking at it... maybe the 52 (shows 50)?
Retrieving data ...