AnsweredAssumed Answered

Create fixture from solid model

Question asked by Ryan Streger on Sep 15, 2017

Hey guys,

  I'm trying to create an electrode (the large thick piece), that has a profile on the bottom opposite of the intended shape of my piece (The thin piece underneath it). Basically, I'm trying to create an innie from an outie if that helps. In Electrode A, I used surface offset to grab the profile, then just thickened and that was easy. However for piece B, surface offset is not grabbing the profile correctly, and it is creating a step on the edge of the piece.  Any help or guidance would be greatly appreciated, I'm just not sure how else to go about this.

Outcomes