2 Replies Latest reply on Dec 2, 2017 7:59 AM by Matt Bieringer

    How to change hole callouts to show "<NUM_INST>" at the end of the note.

    Nick Wagar

      My company does not want to see "(4x) Hole Callout".  They want to see "Hole Callout - 4 PLCS. 


      I can't figure out how to change this so I don't need to manually edit every hole callout out each time.  Any ideas how I can change this setting permanently.?


      I assume it's in the drafting standard, but I can't find out how to edit that detail. 


      I tried adding it in the Holecallout Format TXT file.  But it didn't work...


      Any help would be greatly appreciated.


      I am new to this Forum.  But hopefully will be able to contribute and help out where I can.