9 Replies Latest reply on Sep 14, 2017 5:56 PM by Bill Dempsey

    How to snap ref dimension to center of rectangle

    Bill Dempsey

      Hi

      I'm still quite the newbie with SW(2017).  I am attempting to add some reference check-dimensions at the assembly layer.  One of my components in the assembly uses a machined pin with a "chisel" tip.  I'd like to be able to snap to the center of its face as it is a primary reference point for other pieces that tie in to this assembly.

      I can't seem to find a way for SW to recognize the center of a "square" face.  Am I missing something?

      I am attaching a picture of the assembly. The highlighted blue face is the square pin's face I need to center on.

      Any tips?
      Bill

       

       

      square_pin.jpg