How do I change to direction of the X & Y axis for a hole table?
Ooh, good question!
Not sure that you can. You might have to rotate your entire view, because +X will always be horizontal and to the right.
Ok, after reading Alen's response, I looked a little deeper:
See attached video:
Manually select which edge is the X and which is the Y inside the property manager of the hole table command.
Where ever you select that is what becomes your 0,0 location, this will be reflected in the table. Alen
That's what I needed! Thank you!
Very cool. It never occurred to me that you can reverse the direction like that.
Me neither....I figured it out literally AS I was looking into it. LOL
Retrieving data ...