AnsweredAssumed Answered

Locate component alon8 an angle....?

Question asked by Vince Boice on Sep 5, 2017
Latest reply on Sep 5, 2017 by Dan Pihlaja

I am attempting to place fasteners along the center line of a tapered, sloped face.

 

For example:

A 20' long face that is 24" wide at one end and 20" wide at the opposite end, at an incline of 1.5 degrees.

 

I need to place a fastener 20" from one end, normal to the surface.

I think once I can place one, I can array the remainder of the fasteners at regular intervals, but I just can't figure out how to locate the first one in the correct orientation AND along the center line without the model being over defined.

 

Any help is greatly appreciated.

 

Thanks in advance!

Outcomes