4 Replies Latest reply on Aug 28, 2017 10:00 AM by Peter Kennedy

    Routing - Change Default Pipe

    Peter Kennedy

      I changed the default pipe file as we were running into issues, so I made a new file and went through the routing library manager and setup the new file. Now the one issues I have is I have old assemblies referencing the old pipe file which I deleted. I didn't have that big of an issue as usually our assemblies are one offs however now I have an assembly I need to make changes too and I get this error:

       

       

      When I try and change the routing sketch and the new pipe does not populate.

       

      I changes the pipe in the routing properties to the new file "pipe, in.sldprt" however it still populates that same warning above.

      Is there anyway to fix this or should I just start again.