AnsweredAssumed Answered

How to remove gap between extension line of angle dimension and center mark?

Question asked by Sami Niemonen on Aug 25, 2017
Latest reply on Aug 28, 2017 by Jitendra Gahalot

Hello,

I have a problem in angular dimension as shown in picture. The extension lines are shown correctly as far as I have extension lines of center marks visible but when I hide the extension lines of center mark there is a huge gap between the dimension and center mark. It seems that the dimension extension lines are still attached to center mark extension lines. Any ideas? Extension lines gap is set to 0mm in document properties -> Dimensions. And I tried to drag extension lines to the center of the hole with no success..

Screen Shot 08-25-17 at 01.44 PM 001.BMPScreen Shot 08-25-17 at 01.44 PM.BMP

Outcomes