I cannot get this swept cut to act right. As you can see there is still material left on it. If I increase the length on my profile sketch, it will not rebuild.
SW 2016 SP5
I suspect that you have a portion of the sweep cut which is self intersecting due to the spline.
I was able to work around by doing a delete and patch.
Hope this helps.
..your profile would need to be at least 1" long to cut the corners ...but, when it's increased, it fails as a solid sweep.. alternatively, you can do a surface sweep and cut w/surface.
Yes that was the issue I had. I am not very up to speed on using surface tools! But I appreciate the response. I always like learning new things!
Retrieving data ...