1 Reply Latest reply on Aug 23, 2017 7:02 AM by Mattew Stafford

    Revising weldment profile cut list property question

    Mattew Stafford

      I am trying to revise the callout for each configuration of a structural member.  Currently, the default looks like this:

       

      I can change the description fine, but I am typing something wrong in this location circled in red apparently.  Unless there is a better way, I am

      1.)  changing the decimal callout to fractional (manually)...because that has been a standard callout & it matches most steel supply companies callouts; and calling it "cross section".

      2) adding a "size" property that will populate my bill of material.  This will show the size of the angle and the length.

       

      This is what it looks like after I create a structural member: