AnsweredAssumed Answered

Curved Sheet Metal Part

Question asked by John Scott on Jan 14, 2009
Latest reply on Jan 15, 2009 by John Scott
I have been attempting to make a curved sheet metal circular part...not working. Any suggestions would be helpful. The closest I can get is to make an accurate half, then mirror the part, create assembly but when flattened falls apart.

Sheet Metal Part: Diameter 22" x 0.1345 (10GA.) thick.
Part will be rolled/curved on a 48.1875" cylinder.

So basically it will look like a Pringles potato chip.

Edit: Got it to work in an assembly but there has to be a cleaner way? I will have to get it to work on a conical face too.

Attachments

Outcomes