AnsweredAssumed Answered

Incorrect Design Table Value Break Entire Design Table

Question asked by John Miko on Aug 14, 2017
Latest reply on Aug 14, 2017 by John Miko

I have a design table where I change the height of a bow from 3.9" to 0.2". Previously the design table worked when the height only varied down to 0.35", now that the height has decreased even more, the table does not work. When creating the bow with a height of 0.2" (configuration HAC001 9" Open Hole Design [CLOSED]) I get the warning "Warning: A solution cannot be determined for this sketch." unless I incremently change the value from 3.9 to 3 to 1 to 0.5 to 0.3 to 0.2. By doing this, the configuration builds correctly but then breaks the other configurations. I think it's because solidworks tries to rebuild the part but does not increment the change so I get a rebuild error. Any advice on how to fix this or how to proceed is appreciated.

 

Thanks

Attachments

Outcomes